Disinfectant Spray - Eucalyptus, Spearmint & Thyme

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not spray in eyes.

TO CLEAN:

1. Wet the surface with the spray & wipe clean. For stubborn stains, let stand for a few minutes. Allow to penetrate, then wipe clean.

TO SANITIZE hard, nonporous surfaces:

1. Wet the surface with the spray.
2. Leave visibly wet for 1 minute. Let air-dry. No rinsing or wiping is required (even on food contact surfaces). For visibly soiled or greasy areas, pre-cleaning is required.

TO DISINFECT & DEODORIZE hard, nonporous surfaces:

1. Wet the surface with the spray (spot test to check surface compatibility).
2. Leave visibly wet for 10 minutes. Let air-dry. No rinsing or wiping is required (even on food contact surfaces). For visibly soiled or greasy areas, pre-cleaning is required.

TO CONTROL MOLD & MILDEW:

1. Pre-clean surface.
2. Spray surface until thoroughly wet. Leave visibly wet for 10 minutes. Let air-dry. Repeat weekly or when growth appears.

KEEP OUT OF REACH OF CHILDREN

CONTENTS UNDER PRESSURE.

• Do not expose to heat or open flame, or store at temperatures above 120° F.
• Do not puncture or incinerate container.
• Store airtight at room temperature in areas inaccessible to small children.
• Nonrefillable container.
• Do not reuse or refill this container. Offer empty container for recycling. If recycling is not available, discard in trash.

• No Rinse Required, even on food contact surfaces
• For use in pet areas
• Kills Mold & Mildew
• USDA Certified Biobased Product (Product 100%)
• Non-flammable propellant – compressed air